Exponents Whiteboard & Mobile Display

Cleaning Laminate Markerboard Surface

Use dry erase markers only. Remove dry-erase markings with a markerboard eraser or soft cloth as often as possible. Change erasers, as they become dirty. Dirty erasers will leave ink residue on the surface.

For daily cleaning, or as needed, use a dry erase cleaner, or a non-abrasive household cleaner, such as glass cleaner. This may be done with a soft cloth or sponge. Dry the surface with a soft cloth prior to writing. All markings should be removed weekly.

Caution:

• Do not use permanent markers on markerboard surfaces. In the event a permanent marker is used, removal of markings may be attempted by using dry erase cleaner, or by writing over the marking with a dry erase marker and erasing with a markerboard eraser or soft cloth.
• Do not use abrasive cleaners or solvent type cleaning solutions, such as Ketones (Acetone, MEK, etc.) lacquer thinner, nail polish remover, etc. because they may remove the finish from the markerboard surface.

Cleaning e3 CeramicSteel Markerboard Surface

Wipe board with a clean cloth moistened by a liquid markerboard cleaner or a solution of 50% water and 50% isopropyl alcohol. Rinse with clear water. Wipe dry with a clean cloth If your board is used daily, the cleaning should be performed at least 2-3 times a week. More thorough cleaning may be required if writing is left on the board for more than two days.

Markers

Use any high-quality dry erase marker. CAUTION! The use of Low Odor markers may cause ghosting to occur. If Low Odor markers have been used, the surface can be completely cleaned by following the cleaning instructions above. Remember to discard eraser if used with Low Odor markers.

Removing Permanent Marker Option 1

Write over the top of the permanent marker ink with a dry-erase marker. Simply erase

Removing Permanent Marker Option 2

Moisten a clean, dry cloth with isopropyl alcohol. Wipe the board in a circular motion to loosen marker residue. Rinse with clear water. Dry the board with a clean cloth. Repeat these steps as necessary

Installer’s Instructions for Initial Cleaning at Time of Installation

These initial cleaning instructions are shipped with every board. For initial cleaning, wipe your board with a clean cloth moistened by a mild, alcohol-based cleaner. Rinse with clear water. This step is simple, but very important. Wipe dry with a clean cloth.