Low collaborative conference table 26”H. Round, square, rectangular and elliptical tables for 4 to 8-person available.
Conference and work table 28.5”H. Round, square, rectangular and elliptical tables 4 to 16-person available.
Pull-out tablet. Bring your work to you. Available as an option on select 26" high tables only.
Table glides adjust 3/4" for leveling on uneven floors. Aluminum glides include non-marring plastic inserts.
Performance Power is available with 3 tamper-resistant simplex recepticals and two USB-A/USB-C, 2 tamper-resistant simplex recepticals and 1 blank AAP for customer supplied data, or 1 tamper-resistand simplex receptical, 1 USB-A/USB-C and 1 blank AAP for customer supplied data.
Performance Power has either a 10' power cord with 15-amp plug or a hardwire infeed with 8' cord. Performance Power units with a plug can be ganged together on an individual table.
Performance Power is available on most rectangle and super-elliptical tables positioned between column cones and measures 10 1/2" x 3 3/8".
Simple Power is available with 3 tamper-resistant simplex receptical or 2 tamper-resistant simplex recepticals and 1 USB-A/USB-C.
Simple Power is available on all SW_1 Tables except for 30" and 36" round tables and 30"x30" and 36"x36" square tables. This power type is positioned above column cones and measures 4 4/5" in diameter.
Simple Power module can flip to conceal power when not in use.
When two or more Simple or Performance Power modules are specified, the ganging power option connects all by a corded system and has a single infeed with 15-amp plug. Only one type of power can be optioned onto a single table.
The Cable Tray cleanly routes wires and cables from the worksurface to the vertical wire manager or through the opening in the center of the tray. The bottom opening is 2” x 7 7/8” inches. The cable tray is available to specify on most rectangle and super-elliptical tables.
The optional center grommet hosts a PowerPod with convenient tabletop access to six power outlets, disguised when not in use by an accessory tray.
Wire management. Grommet with wire manager allows wires to be accessed at the tabletop.
The vertical wire manager routes wires down the column on the outside of the leg. Openings in the side of the support cone allow wires from the grommet or Simple Power to pass through.
Tabletops. 1/2" thick tops available in glass, veneer, Corian or laminate.
Recycled/recyclable cast aluminum base.
Length: 84" 120"
40”W x 84”L
40”W x 96”L
44"W x 120"L
48"W x 96"L
48”W x 120”L
Length: 120” 144”
40”W x 96”L
44"W x 120"L
48”W x 144”L
52"W x 168"L
56”W x 192”L
60”W x 216”L
60"W x 240"L
60"W x 240"L
Lendth: 60" 72"
Length: 60” 72”
Powder Coat Finishes
Chairs and table bases should be cleaned with a liquid detergent and water. Remove stubborn stains with liquid cleanser, such as Formula 409®.
Polished Aluminum
Finishes on table bases should be cleaned with a commercial powder, liquid, or paste metal cleaner and polish. Follow the manufacturer’s directions.
Fabric
Under normal use, clean with soft cloth dampened with water. For spots and spills, we recommend professional cleaning. For COM, refer to the specific cleaning instructions recommended by the fabric supplier.
Chrome
Use commercial cleanser and polish, according to manufacturer’s directions.
Leather
Under normal use, regular dusting and vacuum cleaning are all that is necessary. For spots and spills, wipe excess liquid immediately. If necessary, use lukewarm water cleaning the entire area where spot occurred and air dry. For stubborn spots or stains, use a solution of mild non-detergent soap and air dry. For butter, oil, or grease, wipe excess with dry cloth and then leave alone. The spot will dissipate into the leather. Do not apply water.
Granite/Glass
Under normal use, clean with Windex and soft cotton cloth.
SW_1 tablet surfaces
Clean with soft cloth dampened with water and soap, if needed. The use of general purpose cleaners are acceptable but must be void of citric content that has z-butoxyethanol in the formulation listing.
Laminate and Solid Phenolic
Clean with soap and water. For stubborn stains, use a non-abrasive household cleaner.
Veneers and Painted MDF
Clean regularly with mild soap and water and dry with a soft cloth. Tip: Never use ammonia-based cleaners or wax on wood surfaces.
Inspection
Tables should be inspected and maintained regularly by tightening screws and bolts, inspecting casters and glides for damage, and inspecting all moving parts for damage and wear.
Transolid/Corian
Clean regularly with mild soap and water. Dry with a soft cloth.
Carl Hansen Wood Finishes
Oil/White Pigmented Oil: Wipe clean with damp cloth. Wood should be treated twice per year on all surfaces, or as needed to remove scratches and stubborn stains. Stain/Varnish, Clear lacquer, CHS Color: Wipe clean with damp cloth.
The beauty and clever design of standard height SW_1 Conference Tables can be paired with the SW_1 Conference Chair. Meet at a lower level with the SW_1 Collaborative Table alongside the SW_1 Lounge. Three inches lower than standard tables, it elevates collaboration.
Design — Scott Wilson & MINIMAL
SW_1 redefines the concept of collaborative workspaces with guest and conference chairs, lounge seating and tables.
